"ERider torque sensor and crankset for 68mm or 73mm wide bottom bracket shells with a 4 bolt or 5 bolt 104mm or 130mm (respectively) spider, compatible with most triple chainrings found on mountain bikes. Unlike most other bottom bracket torque sensors, the ERider-T9N model has a cable exit from the side of the cartridge and does not require drilling a hole through the frame. This torque sensor accurately measures both left and right pedal torques and enables a very responsive PAS system.
Includes 0 Q factor 165mm Miranda Cranks.
Chainrings are not included and would typically be moved over from the original crankset to this one during installation.
This sensor has an 18 pole single wire cadence sensor and a 1.5V - 3.5V output voltage that is proportional to crank torque with a scaling of 70 Nm/V. Includes 90cm long cable terminated with JST-SM connector, plug-and-play with V3 Cycle Analyst
Actual Weight (kg) 1.06
Country of Manufacture China
Connector(s) Higo Signal C, JST-SM
PAS Poles 18
PAS Encoder Style 1-Wire
Torque Scale (Nm/V) 70
^Above information and pictures are provided by the distributor, Grin Technologies.